Michigan Airsoft
Gear => Clothing & Load Bearing Gear => Topic started by: Gr1zzly on March 23, 2018, 07:57:15 PM
-
Putting together my OD outfit and it’s basically coming out Vietnam-themed (which is fine by me since I’m getting an M14 and 1911). Planning to go with a boonie hat, but I’ve been thinking about those classic Nam helmets with graffiti. A metal repro costs at least $150, so I’m considering getting a repro M1 helmet liner (made of plastic with all the head straps inside) for $25 and just putting a helmet cover on it. It’ll be a lot lighter and a real steel helmet seems like overkill for airsoft. Does this seem like a bad idea? The liner is a few milimeters smaller than a helmet but looks just like a full helmet.
Here’s the liner: https://www.epicmilitaria.com/repro-us-m1-helmet-liner.html
-
I would do it, honestly I've found I use a helmet allot on the field which sounds silly but it's saved my melon a few times;) I don't need anything crazy but I started wearing one after falling off the bumper of the van on our field. My own fault I was doing something I shouldn't have been and acting like I was 18 again. Either way I got thinking I should wear a helmet, started doing it and most of the time on the field if I'm not in a sniper setup then I've got a helmet on. That said I a painted old school ProTec skate helmet I used to use skating 20 years ago. Works fine, it's comfortable and I figure if it was safe enough for half pipes it's perfectly fine for my knocking my head into stuff;)
But yeah I'd do it, somewhere I've got a legit kevlar helmet forget the model at the moment, but even that is dang heavy for my neck and back anymore on the field. Sure I could run it, but the thing for me is realism is secondary to me being comfortable the next day after playing airsoft;)
So yeah I'd do it;)
Luke
-
Putting together my OD outfit and it’s basically coming out Vietnam-themed (which is fine by me since I’m getting an M14 and 1911). Planning to go with a boonie hat, but I’ve been thinking about those classic Nam helmets with graffiti. A metal repro costs at least $150, so I’m considering getting a repro M1 helmet liner (made of plastic with all the head straps inside) for $25 and just putting a helmet cover on it. It’ll be a lot lighter and a real steel helmet seems like overkill for airsoft. Does this seem like a bad idea? The liner is a few milimeters smaller than a helmet but looks just like a full helmet.
Here’s the liner: https://www.epicmilitaria.com/repro-us-m1-helmet-liner.html
Look around local surplus stores and often you'll find the M1 helmets for a ton cheaper. I bought mine a few years ago for $64, though be warned it weighs a couple of pounds so long term use is exhausting. But the protection as well as the look and feel are worth it.
Sent from my SM-G360V using Tapatalk